Jump to content
BiXBiT Alternative firmwares


  • Content Count

  • Joined

  • Last visited

  • Days Won


BiXBiT last won the day on December 26 2018

BiXBiT had the most liked content!

Community Reputation

2 Neutral

1 Follower

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Здравствуйте, включите в настройках immersion mode - on
  2. Up to 85 Th/s but you need to aware that the temperature is can't be above than 100C. For profile you are using right now, your hottest chip is showing 75C.
  3. Hi, it seems everything goes right. Your chips are working at almost 100% of their potential. What HR do you have now?
  4. Hi, for first i will recommend you to use autotune instead of choosing profile. This process can take up to for few hours. After finishing this process your asic will work much efficiently. Increasing temperature for pcbs/chips more than 100c will increase a chance of damaging your hardware.
  5. Hello radom, there is no need to pay additional payment. When you are using this firmware commission does automatically from your current HR.
  6. Hi, Julian. Check your log file, it seems your asic is overheated.
  7. Hi, Daniel. Try to recover your ASIC firmware by using SD-card. You can find IMG file at the top of this topic.
  8. Здравствуйте, не сброс до заводских настроек, а восстановление прошивки через sd-карту. Образ прошивки в первом сообщении. p.s. У вас вирус
  9. Hi, Julian. Check the first page > If the firmware of your device was released after August 2019, you need to install the earlier version before upgrading to BiXBiT firmware. ( To find your current version check the system tab )
  10. Здравствуйте, похоже на вирус. Попробуйте восстановление образом.
  11. Hi, Diderick. Try to use both last password and admin root
  • Create New...