Is using a custom ASIC firmware from BiXBiT free?

Our software for Antminer, Whatsminer is distributed for free. Please keep in mind that custom firmware includes Developers Fee, which is a reward for developers. Usually it is 1.8%-2.8% of the miner’s total hashrate which is automatically deducted during the work of the device.

Why the ASIC does not start after selecting a profile?

If you mean the very first run after flashing the device, it sometimes takes up to an hour for the inbuilt algorithm to finish configuring your ASIC.

How to bypass the “Cannot Find Signature” message during the flashing process of the ASIC?

Read our user manual for your specific miner version, it describes actions to eliminate this error, when it occurs.

Does the ASIC lose its warranty from the manufacturer when used with a custom firmware?

There is no definite answer. To avoid warranty issues, please use the firmware from the manufacturer.

Is it risky to use the custom firmware for ASIC from BiXBiT?

Absolutely not. All firmware revisions are thoroughly tested before each release. Moreover, all BiXBiT capacities have been running on these firmwares for many years.

Is BiXBiT AMS compatible with microprograms from other developers?

No. Our automated monitoring system is only compatible with our software.

Is it possible to revert the ASIC back to its original settings after using a custom firmware?

Yes, just bring back the official firmware in the usual way.

What level of knowledge is required to flash a miner?

We have specially made instructions for every version of the miner. Everything is described in a simple and clear way, so even a beginner can handle it. Besides, you are always backed with our team of technicians who are always in touch and willing to help.

All documents

Leave your email so you don't miss out!

By subscribing, you agree to our

1. TECHNICAL REQUIREMENTS

REQUIRED HARDWARE:

A power supply network, wiring, and circuit breakers (protective breakers) corresponding to the device's specifications.
A router with internet access.
A computer connected to this router.
An Ethernet cable ("twisted pair"/"patch cord") for connecting the ASIC miner to this router.
In some cases, a microSD card may be required. It is recommended to use SD cards with a capacity ranging from 2GB to 16GB.

The device does not have a wireless communication module and requires an Ethernet cable connecting it to the router / switch / modem on this network.
Important: your computer must be on the same local network as the ASIC miner.

REQUIRED SOFTWARE:

WhatsMinerTool. Download the latest version of WhatsMinerTool at the following LINK. Using outdated versions may lead to unsuccessful firmware installation.
BiXBiT FIRMWARE compatible with the device.
Any Internet browser.