Is using a custom ASIC firmware from BiXBiT free?

Our software for Antminer, Whatsminer is distributed for free. Please keep in mind that custom firmware includes Developers Fee, which is a reward for developers. Usually it is 1.8%-2.8% of the miner’s total hashrate which is automatically deducted during the work of the device.

Why the ASIC does not start after selecting a profile?

If you mean the very first run after flashing the device, it sometimes takes up to an hour for the inbuilt algorithm to finish configuring your ASIC.

How to bypass the “Cannot Find Signature” message during the flashing process of the ASIC?

Read our user manual for your specific miner version, it describes actions to eliminate this error, when it occurs.

Does the ASIC lose its warranty from the manufacturer when used with a custom firmware?

There is no definite answer. To avoid warranty issues, please use the firmware from the manufacturer.

Is it risky to use the custom firmware for ASIC from BiXBiT?

Absolutely not. All firmware revisions are thoroughly tested before each release. Moreover, all BiXBiT capacities have been running on these firmwares for many years.

Is BiXBiT AMS compatible with microprograms from other developers?

No. Our automated monitoring system is only compatible with our software.

Is it possible to revert the ASIC back to its original settings after using a custom firmware?

Yes, just bring back the official firmware in the usual way.

What level of knowledge is required to flash a miner?

We have specially made instructions for every version of the miner. Everything is described in a simple and clear way, so even a beginner can handle it. Besides, you are always backed with our team of technicians who are always in touch and willing to help.

All documents

Leave your email so you don't miss out!

By subscribing, you agree to our

4.4. Updating BiXBiT Firmware to a Newer Version on Any Control Board Model

Launch WhatsMinerTool and set the scanning range to include the IP address of the device for firmware installation. Start the scan and make sure the device appears in the list.

Step 1: Click [Upgrade].
Step 2: Click [Select File].
Step 3: In the pop-up window, select the file “Whatsminer-ALL-Models_X.X.X.X.bin” from the archive you previously downloaded and extracted (X.X.X.X is the firmware version).
Step 4: Confirm the file selection by clicking [Open].
Step 5: Check the box to the left of the IP address of the device whose firmware you want to update. You can select multiple devices if they have compatible control board models and firmware versions.
Step 6: Click [Start Upgrade] to begin the update process. In the confirmation dialog that appears, click [OK]. If the update is successful, the Status column next to the device’s IP address will display “Success”. The device will then reboot automatically. After the reboot, open the device’s web interface. If the installation was successful, you will notice changes in the interface.